Prominent Paints Premium Matt is a premium quality fully washable acrylic with a classic matt finish. The surface ensures almost no light is reflected thereby making brush marks almost invisible. It was developed for surfaces such as ceilings, wood, steel and areas of your home where high traffic occurs such as passage walls and bedroom walls. Its superior formulation ensures that dirt can be easily wiped off without leaving any shiny patches.
Prominent Premium Matt is available white, pastel tint base, clear tint base and standard colours in the following pack sizes: 1lt , 5lt and 20lt
White and colours as per latest colour card. Tint bases to tint most of the colours on the tint system.
Please note: Every care has been taken to ensure that the colours displayed on this website reflect the actual paint colour as accurately as possible. Colours may vary due to your screen settings and resolution. Always consult a Prominent Paints colour card or stripe card before making your final colour choice.
Spreading Rate: 6m² - 10m²/litre, dependent on surface texture and porosity.
Solids: ± 54% by mass and ± 35% by volume.
Density: ± 1,27 kg/litre.
Recommended Dry Film Thickness: 2 coats at 40µm per coat minimum.
Viscosity: ± 110 Kµ.
Flash Point: Non-flammable.
Available Sizes: 1Lt, 5Lt, 20Lt
Colours: White and colours as per latest colour card. Tint bases to tint most of the colours on the tint system.
Life Expectancy: 12 years for specified interior and exterior applications.
Calculated Maximum VOC: 16g/L maximum for white and pastel tinting base and selected standard colours.
Respecting The Environment:
Touch dry - 30 minutes.
Note: Higher temperatures will accelerate the drying times (approximately halved for every 10°C increase), whilst lower temperatures will retard the drying time (approximately doubled for every 10°C decrease).
4 hours at 23°C.
Surfaces must be sound, clean and dry (moisture content below 15%) before painting. Plaster sand to comply with SABS 1090 requirements. Plaster mix must have a minimum thickness of 10mm, free from soft and friable material and comply with SABS 0164-1 for strength (MPA).
Exterior Cement plaster:
Interior Cement plaster:
Gloss paint and Eggshell Enamel:
Sheen emulsion paint:
Matt emulsion paint:
Poor condition surfaces, i.e. excessive peeling:
The tint base containers are only filled to levels which are specific for each tint base to allow the calculated volume of colourant to be added in order to achieve the volume indicated on the container after tinting. Tint bases and colourants are unfinished products which should not be used on their own. Only once the prescribed colourant is added to the specific tint base will the finished product comply with the technical features and related information as set out in this TDS. 4. The calculated max VOC compliance < 16g/L is only applicable to product tinted from Pastel Base, excluding Clear Base.
Colourant to be used:
Prominent colourants are lead free specifically formulated for use with Prominent Pro-Matic tinting system. ICC colourants which are lead free using only Prominent supported formulations on Largo 2000.
Pastel Base and Clear Base.