Features

• Quick drying.
• Can be overcoated after 2 hours.
• Corrosion resistant.
• 100% lead free.

Intended Usages

• New, unrusted metal as a primer.

Application Details

• Mixing: Stir before use with a flat paddle to an even consistency. Stir occasionally during use.
• Method: Brush or spray.
• Thinning: ProGold Lacquer Thinners.
• Cleaning: Remove as much of the product as possible from the application equipment before cleaning with ProGold Lacquer Thinners.

Conditions:

• Temperature between 5°C and 40°C.
• Relative humidity of less than 85%, preferably between 10: 00 and 16: 00.
• Ideally apply when the temperature of the substrate is at least 2°C above dew point.

Drying time: 
Surface dry - 15 minutes, Hard dry - 2-3 hours at 23°C with a relative humidity of 85% or less. 
Note:  Higher temperatures will accelerate the drying times (approximately halved for every 10°C increase), whilst lower temperatures will retard the drying time (approximately doubled for every 10°C decrease).

Recoating time: 2 hours to 14 days.
Requirements: One coat.

Surface Preparations

• De-rust and degrease using ProGold General Purpose Cleaner/water mixture (1: 5), rinse with clean water, allow to dry and apply one coat.
• Not for redecorating.

Limitations

• Poor anti-corrosive properties on rusted steel.
• Cannot be overcoated with Prominent 2 Pack Floor Epoxy or Prominent 2 Pack Polyurethane Floor coating.
• Thicker coatings take longer to dry thoroughly.
• Wrinkling can occur if recoating times are not adhered to.
• To ensure a consistent appearance ensure that batch numbers on all the containers are the same. Where the batch numbers differ, intermix before use.

Safety

• Keep out of reach of children.
• Ensure to maintain good ventilation during application and drying process.
• In case of skin contact, wash with soap and water or a recognised skin cleaner. Avoid contact with eyes. In case of contact with eyes rinse immediately with running water and seek medical advice.
• If product is ingested drink plenty of water or milk. Do not induce vomiting at any time. Seek medical advice.
• Refer to the Material Safety Data Sheet (MSDS) for detailed information about the product and transportation and classification criteria. MSDS is available on www.prominentpaints.co.za or from Prominent Customer Service Department.
• To avoid any risk of spillage, always transport in a secure upright position.